**NOTE some printers may need a short back riser, I have included a shorter version which angles up slightly more to compensate, I recommend printing all parts at the same time and choosing the one that suits your printer.

If you want the best performance and the lowest noise from your K1, this is the way to do it.  This is simple, it looks good (Like nothing has been added) as long as you print from grey or black, and it gets the chain up higher and away from the head and motor shroud to give it the space it needs. 

The chain will still make contact with the inside of the top when printing towards that side, I also recommend using silicone weather stripping along that side on the inside of the top to stop that little bit of possible noise that's left. 

Will require:

1 Pc - Thin walled PTFE @ 19mm Long (Head)

1 Pc - M3 x 25mm Machine Screw (Head)

1 Pc - M3 Washer (Head)

2 Pcs - M3 x 10mm Machine Screws (Rear Riser)

This print should be made from ABS or PC, PETG may work, but I don't recommend it.

PRINT SETTINGS

• Layer Height - 0.16
• Walls - 5
• Infill - Gyroid 35%
• Btms - 4
• Tops - 4
• Cooling - Full (All Fans)

Print slower or with more parts, these are small parts and cooling can be a problem.

ENJOY!