Tiki Drinking Monkey

This is an art tile I made for the wall of my tiki bar. It shows my spirit animal enjoying a stiff drink. Longer print time but few filament changes.

I've also found that using a dark blue/purple instead of black will give a nice effect with this print.

----------------------------------

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA Black
PLA Gray
PLA Metallic Gold
PLA White

Swap Instructions:
Start with Black
At layer #7 (0.64mm) swap to Gray
At layer #14 (1.2mm) swap to Metallic Gold
At layer #17 (1.44mm) swap to White for the rest.