this is a hueforge wall art of some Palm trees with the sunset in the back ground.

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.24mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA+ Sunlu Blue Transmission Distance: 4
PLA+ Sunlu Sunny Orange Transmission Distance: 8
PLA BambuLab Basic Yellow Transmission Distance: 6
PLA+ Sunlu White Transmission Distance: 5

Swap Instructions:
Start with Black
At layer #10 (0.6mm) swap to Blue
At layer #14 (0.76mm) swap to Sunny Orange
At layer #28 (1.32mm) swap to Yellow
At layer #38 (1.72mm) swap to White for the rest.

please follow the settings in the bambu wiki seen below for best Results.

(1) Adjust the min layer height to 0.04 mm.

(2) Confirm specific process parameters