Quest 3 to Quest Pro interface

Remixed by

Quest 3 to Quest Pro interface

Remixed by
Boost
5
8
2

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
1.1 h
1 plate

Boost
5
8
2
0
16
7
Released

Description

This is a remix to remove the lower part of the facial interface (not really needed and it keeps popping out anyway! lol) and reduce the top part so the bobovr m3 forehead touches the top of the interface giving a bigger surface area and also with the strap attached (Velcro) makes it more solid. 

Comment & Rating (2)

Please fill in your opinion
(0/5000)

I am about to print this but I would like to have an understanding of your orientation. Should I print as it imports? What is the best setup that you have been able to do for this?
The designer has replied
0
Reply
You can alter the orientation that suits you, I found that in the orientation that I've set allows for a slightly faster printing time as it uses less support, but you must make sure your bed is clean before printing, laying it more flat takes longer and more support but does give better contact to the build plate.
0
Reply
No more