Basic Funnel by jcbohman

jcbohman

3D Printer>3D Printer Accessories

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.16mm layer, 4 walls, 80% infill

Designer

2.4 h

1 plate

4.7(53)

Boost

253

215

Released

Description

Honestly, I couldn't find a funnel to use to transfer recharged desiccant from my oven pan back into the original container, so I modeled one really quick in Fusion and printed it…

Smaller hole outer diameter is 25mm and the larger funnel portion is 138mm

I know it's overkill, but I printed this with four walls, so the only infill was in the little handle, so it is very sturdy.

I've included a 3mf, stl and .step file.

funnel

dessicant

Comment & Rating (63)

@Thully

Print Profile

0.16mm layer, 4 walls, 80% infill

Overhangs didn’t print well with Bambu PLA

(Edited)

The designer has replied

@jcbohman

looks like stringing. was your filament dry?

@Thully

Bone dry. I dry all of my PLA filament at 55c, then vacuum seal it with desiccant and digital hygrometers. I make sure the humidity is below 20% before printing. I very rarely have any print failures, however this profile struggled with the inside overhangs.

@jcbohman

Replying to @Thully :

mine printed smooth and cleann, as far as I can tell so did a lot of other peoples print. I it printed clean enough enough that I can barely see the seams on my print. sorry it didn’t work out for you.