Apple Pencil Case by danielha2058

danielha2058

Tools>Organizers

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

1.3 h

2 plates

4.4(5)

Open in Bambu Studio

Boost

113

140

Released

Description

Summary

Note, please use the latest version: https://makerworld.com/en/models/721741#profileId-652629

The original packaging of Apple Pencil also comes with a pen tip and charging interface. Because there is no suitable storage, it is inconvenient to charge and find it frequently, and it is easy to lose in several boxes, so I designed this pen box, 13mm x 13mm x 243mm, size It should be the limit, because the diameter of the pen is only 8.9mm. It is connected with hinges and has a rope hole on it, so you can tie it up with a rope so you don’t have to worry about falling out when traveling. The opening of the pen still follows the original design, making it easy to buckle the pen from the tip without bumping the tip.

The two parts are printed separately, with the opening facing upwards, without support. After printing is completed, the two parts are spliced together.

Also suitable for Apple Pencil 2nd generation

Printing using bright green PLA takes 55 minutes and uses 26g of consumables.

Apple Pencil 原本的包装里面还附带有笔头和充电接口，因为没有合适的收纳，经常充电寻找不太方便，而且好几个盒子很容易弄丢，所以设计了这个笔盒，13mm x 13mm x 243mm，尺寸应该是极限了，因为笔直径就8.9mm。使用合页连接，上面留有穿绳孔，可以用绳子绑起来，旅行出门也不用担心掉出来。笔的开口还按照原设计，方便从笔头处将笔扣起来，也不会将笔头磕碰到。

俩部分分开打印，开口向上，无需支撑，打印完成之后，将两部分拼接起来。

同样适配 apple pencil 2 代

使用亮绿色PLA打印，用时55分钟，耗材26g。

apple

applepencil

box

Comment & Rating (17)

@Q50_Drew

Print Profile

0.2mm layer, 2 walls, 15% infill

I liked the print, very handy for my daughter who constantly loses her pencil. The slide cover seemed a little bit too large to stay on, so I embedded some magnets to keep the case closed and with good strength. love the design! my recommendation would be to make the pencil snap into place and a little more space for the adapter so it’s not difficult to pull it out

@isaiahguerrero

Hi I've modified the print file so the clip fits properly and securely. It’s now up in the remixed section

@Q50_Drew

cool! thanks for the reply. I’ll try it out

@AeonJoey

Print Profile

0.2mm layer, 2 walls, 15% infill

it printed out okay, but I regret printing it since the design is so loose that it doesn’t stay closed and the clip is too loose to stay anywhere, I don’t understand how the “rope hole” is supposed to work since nothing is keeping the case closed and the Apple Pencil just falls out. I inserted a large rope thinking it would rub against the clip and it still doesn’t stay put, it just slides itself off and falls off. i see in another comment that someone embedded magnets, I’m going to try that.

(Edited)