The shelf/plank holders of our kitchen Bruynzeel cupboards were broken. I needed both left and right sided models.
The shelf plank height is about 16mm, the metal rod is about 5mm diameter.
Included Fusion 360 archive to allow tinkering with the design.
Printer:
BIQU B1
Rafts:
No
No
Resolution:
0.16
Notes:
Print this will fully walls (so the slicer won't slice any infill). Lower layer height increases print strength. Print this with cooling fan off to further increase strength.
Take the metal rod and insert into the print. By using a little persuasion it should insert - otherwise heat it up a bit.
Category: Kitchen & Dining