这是一个简单的用于为其他3d模型进行磁铁安装的帮助性工具。我们常会忘记磁铁的磁极，以至于在安装时困惑。这件工具可以让你在安装时判断清楚磁极，以便安装顺利，无论是预埋式安装还是粘贴性安装。

⚠⚠⚠ 这个模型需要进行预埋磁铁，需要在打印过程中进行暂停以埋入磁铁！！⚠⚠⚠

该模型需要额外的两个2mm高，6mm宽的圆形磁铁，也可以选择小于这个大小的磁铁。我预留了2.4*Φ6mm的圆柱形孔洞。

请注意，在切片软件中进行切片时，请在孔洞即将封闭顶部时，即“封闭层”的下一层（-1层）进行暂停。

将右侧层进度条拖动到相应层数，右键即可添加暂停。

如果您采用0.2mm精度，可以在18层，125层加入暂停，或者直接采用我的文件，这应该已经添加过了（…可能？）。

在暂停后放置磁铁，继续进行打印即可。（记得区分磁极！！如果顺利的话这将是你唯一一次区分磁极了。）

要注意！硬化钢喷嘴可能会吸附磁铁！请使用不锈钢喷嘴进行打印！

再次强调：

是否需要支撑：否

材料：pla，petg

额外配件：2*Φ6mm的圆形磁铁*2

磁铁添加方式：预埋

是否需要暂停：是

This is a simple helpful tool for magnet mounting for other 3d models. We often forget the poles of magnets to the point of confusion when mounting them. This tool will allow you to determine the polarity of the magnet so that the installation goes smoothly, whether it's a pre-built installation or a stick-on installation.

⚠⚠⚠ This model requires pre-buried magnets and requires a pause in the printing process to bury the magnets!！⚠⚠⚠

This model requires two additional 2mm tall, 6mm wide round magnets, or you can choose magnets smaller than that. I reserved 2.4*Φ6mm cylindrical holes.

Please note that when slicing in the slicing software, please pause when the hole is about to close the top, i.e. the next layer (-1 layer) of the "closed layer".

Drag the right layer progress bar to the appropriate layer and right click to add a pause.

If you are using 0.2mm precision, you can add a pause at layer 18, layer 125, or just use my file, which should have already been added (...maybe?).

Just place the magnet after the pause and continue printing. (Remember to differentiate the magnetic poles! ！！If it goes well this will be the only time you distinguish the magnetic poles.)

Be aware! Hardened steel nozzles may attract magnets! Please use a stainless steel nozzle for printing!

Emphasize again:

Whether support is required: No

Material: pla, petg

Extra accessories: 2*Φ6mm round magnets*2

Magnet adding method: pre-buried

Whether need to pause: Yes

(Mechanical translation, if there is a misunderstanding can be commented.)