Print Profile(1)
0.16mm layer, 4 walls, 20% infill
Designer
1.4 h
1 plate
Boost
17
18
5
0
36
28
Released
Description
When working on your car's engine for a long time, the hood struts can lose pressure and the hood can fall unexpectedly, causing serious injury. This simple gadget attaches to the hood struts and prevents the hood from falling, even if the struts are weak or damaged.
It is easy to install and use, and it provides peace of mind knowing that your hood will not fall on you.
Comment & Rating (5)
All
Print Profile
0.16mm layer, 4 walls, 20% infill
I printed 3 of these at one time. All 3 broke first time I used them. the threaded part needs to be stronger especially where thr handle meets the treads.
The designer has replied
0
Reply
I'm sorry to hear that. What filament are you using? I tested it with Bambu PLA Tough and it worked fine for me although PETG or ABS could be better.
0
Reply
Print Profile
0.16mm layer, 4 walls, 20% infill
0
Reply
Print Profile
0.16mm layer, 4 walls, 20% infill
0
Reply
Print Profile
0.16mm layer, 4 walls, 20% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld