Sunlu S2 stabiliser and side mount by EngineerPro

EngineerPro

3D Printer>3D Printer Accessories

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 4 walls, 15% infill

Designer

5.5 h

1 plate

4.7(7)

Open in Bambu Studio

Boost

107

Released

Description

Side mount and stabilizer for the Sunlu S2 filament dryer, there is an indent under the printer that fits the raised “key” of the holder to hold it securely.

Attention

To “lock” it under the printer you need to use extensions for the feet, such as these https://makerworld.com/en/models/192730#profileId-213032.

Comment & Rating (15)

@user_135681931

I printed this and it came out very nice, but I think there must be different bases for the X1C. The only spot this fits in a "key" is on the front and back. on the sides of mine the bottom plastic is molded for as a hand hold for picking the unit up. The key area on the sides is much smaller than the key on the holder.

The designer has replied

@_hsb_

Hi, the key I use is toward the front on the side from the hand hold mold, and not as deep.

@user_135681931

Replying to @_hsb_ :

Thanks for the information. I will give it a try when I get home.

@user_3756112297

Same issue here.

@user_3756112297

Print Profile

0.2mm layer, 4 walls, 15% infill

Printed great. No issues.

The designer has replied

@_hsb_

great! align and put the ”key” under the printer to lock it

@user_3756112297

Replying to @_hsb_ :

I can only place it in the middle due to things behind and in front of it. So the middle is where I need it to "Key" in. So, I guess I need to see if I can modify it some.