Search models, users, collections, and posts
Demon
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 25% infill
Designer
8.9 h
1 plate
Open in Bambu Studio
Boost
17
35
1
1
9
7
Released
Description
A 3d print of a demon covered in fur and spikes. I used PETG for the filament, but others should work fine as well. Takes about 155g of filament and 8 and half hours of print time. I focused on cutting down time while keeping quality, while at the same time, keeping tree supports easy to remove. I enjoyed this piece. If you do as well, please, leave a like, follow, or boost! Thank you!
License
This user content is licensed under a
Creative Commons Attribution-NoDerivatives
Comment & Rating (1)