Can and food holder
Remixed by
Copyright Claim
Can and food holder
Remixed by
Boost
18
28
6
Print Profile(1)
PLA - 0.2mm layer, 3 walls, 15% infill
Designer
2.3 h
1 plate
Boost
18
28
6
0
37
28
Released
Description
It prevents accidental knocking over your drink and allows you to take your snacks with you.
This remix is adjusted to 66mm can diameter such as Monster Energy 500ml or Cider 440ml.
Comment & Rating (6)
All
could use a hole in the bottom to prevent the can from creating a little bit of a vacuum
The designer has replied
1
Reply
Originally the suction/vacuum-ish helps to keep the can attached to the holder. I use a straw to drink from the can if I put also some food. 😅
0
Reply
fair point! I'm just delighted I found it. I was looking for something I could modify into a cup holder that wouldn't tip over on the bed. I didn't expect to actually find what I really wanted!
0
Reply
Print Profile
PLA - 0.2mm layer, 3 walls, 15% infill
perfektni!
0
Reply
Print Profile
PLA - 0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
PLA - 0.2mm layer, 3 walls, 15% infill
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld