Steam Deck Killswitch Dock by The Spirit

The Spirit

Hobby & DIY>Electronics

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.16mm layer, 2 walls, 15% infill gyroid

Designer

2 h

1 plate

5.0(1)

Open in Bambu Studio

Boost

Released

Description

I needed a Dock for my SteamDeck including the KillSwitch Case.
Since i play in handheld mode and in docked mode i barely need the Kickstand and have it removed most of the time.

But when i want to put it away, i like to have it nicely seated in my office. In order not to attache and remove the kickstand every time in needed a Dock which can hold the SteamDeck with the Killswitch Case.

Therefore i remixed the DBrand Killswitch Adapter for JSAUX Steam Deck from @nomad_alto_695008
and added the support part of another Dock from @loicloic

----------------

update 1.1:

fixed model not lying properly flat on print plate

Comment & Rating (10)

@PrintCreationz

This might be why peoples first layer are failing not sure why its happening tho. Could be a problem with the model. Edit- Figured it out... the base of the model is not flat i fixed it and my gcode seems fine now as well as my first layer

(Edited)

The designer has replied

@TheSpirit

thanks for the hint. i fixed this problem and uploaded the new stl and a print profile with the new version

(Edited)

@Encore94

Print Profile

0.16mm layer, 2 walls, 15% infill gyroid

top !

@Xeromem

The print profile is no longer public

probably my fault but first layer defect failed again

(Edited)

The designer has replied

@Tridense

perhaps you need to check the filament, printer and nozzle, and buildplate you are using before you hit print?

@sorendba

Replying to @Tridense :

my first layer spaghetti too, i Think you are going way too fast on First layer

@Tridense

Replying to @sorendba :

Clean your build plate with isopropyl alcohol, make sure you have the correct buildplate selected in the slicer, make sure you have bed levelling enabled, make sure your filament profile has a heated buildplate with the selected buildplate.

@sorendba

The print profile is no longer public

fails First layer

The designer has replied

@Tridense

You need to check your filament you are using is dry and the correct one for the profile (PLA), that you are using the textured PEI sheet for the build plate and if not change it, that you are using the P1S printer and if not change it to your printer. This is not the fault of the print profile. I have made many print profiles and this one is not any different in the settings from all the other ones.

(Edited)