APFSDS 25 mm M919
Copyright Claim
APFSDS 25 mm M919
Boost
69
107
35
Print Profile(6)
Cartridge case
Designer
2.4 h
1 plate
Projectile with fins
Designer
1.3 h
1 plate
Retaining ring
Designer
10 min
1 plate
Sabot and Nose cap
Designer
1.6 h
1 plate
Click to see more
Open in Bambu Studio
Boost
69
107
35
5
167
123
Released
Description
This is a replica model of the M919 25mm caliber ammunition. This is a highly penetrating ammunition, used for example in the IFV M3A3 Bradley.
Perfect for decoration for military enthusiasts or gamers.
Model is full size, however not 100% accurate. This is a demonstration model only.
You can print it all at once in one color or in 4 colors with AMS or individual parts separately according to colors, which i recommend due to lot of waste with AMS.
The projectile is in two parts and requires glue.
The parts of the sabots are supplemented with a cavity for magnets, which, however, are not necessary, thanks to the locking ring.
Comment & Rating (35)
All
Love the model!
The designer has replied
0
Reply
Thanks :)
0
Reply
Print Profile
Projectile with fins
Split the round in half so I could place a name on the print for a gift. Thanks for a great upload, any chance you could do the 3 piece round that British tanks use?
Cheers brother.
(Edited)
The designer has replied
0
Reply
To be honest, I don't know what the nickname 3 piece wound is for. Is it a standard subcaliber APDS? Anyway, I'd like to make more interesting ammo models in the future. Like the Ahead sub projectile ammo used by the Puma 2.
By the way, I like your skull idea. :)
0
Reply
Print Profile
Cartridge case
great!
(Edited)
0
Reply
Boosted
Print Profile
Sabot and Nose cap
Printed great
0
Reply
Boosted
Print Profile
Cartridge case
Printed great
0
Reply
Boosted
Print Profile
Retaining ring
Great print
0
Reply
Boosted
Print Profile
Projectile with fins
printed great
0
Reply
Boosted
What are the dimensions of the magnets?
The designer has replied
1
Reply
Ideal would be magnets with diameter of 3 mm and height 1,5 mm, but the holes could be adjusted with a drill.
1
Reply
Boosted
thank you
0
Reply
Print Profile
Projectile with fins
(Edited)
The designer has replied
0
Reply
Sorry, but it's meant as a decoration, not a structural component. Intentionally there is low infill for higher print speed.
0
Reply
Replying to @herol
I understand but when I was removing the support material from the penetrator the penitrator snapped other than that it was perfectly fine I’ll give you a 4/5
0
Reply
Replying to @slingshotbaseju
Thank you and I understand, in that case I will probably increase the infill after all.
0
Reply
Print Profile
Projectile with fins
nice little print will make a good display.
The designer has replied
0
Reply
thanks 🙂
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld