I’m not sure what happened but the print failed at same spot twice. the second time the plate was washed with soap and water, dried properly and even tried a different pla. adhesion no problem until this part then the printer starts to knock into the print and knocks it over
That's strange damn, for me and many others it printed without any problem :/ how was the print orientation?
I tagged you in another comment maybe he can help you out..
only suggestion i have is go to at least 65c bed temp and when something fails for me i try it again with slower print speed..maybe switch to 50% when print is almost at the point where it failed..
just as per the uploaded file , I’m using the standard 0.4 nozzle, will try again slowed down. the bottom jaw no problem at all and I’ve printed heaps of prints since doing this one and they had no issue. so I think I ruled out machine and filament. again it goes fine both times till the nose. the second time I sat around until it got to the nose to check what’s up and I watched as the machine started knocking it. thought might be ok but yeah fell over haha
Thanks for your 2 stars :)
The fact it fell over and printed spaghetti just screams user error because your printbed was not cleaned imo.
This is the first time someone has complained about printing spaghetti or print tipping over.. out of over 100 prints for this profile..