Tearranuat Bed Conversion (Removable)

Hello. Thank you for looking at my Terranaut Model conversion. This is a Cargo Bed for the Hobby plus Terranaut 8X8. This is a removeable model and uses the Semi Hitch as the locking mechanism for the bed. It can be unlocked using the tongue lever and remove so you can still use a trailer.

You will need 2 m3X16 Screws

And some barrel nuts: https://a.co/d/4g8N4EO from amazon
and some CA Glue or Double-sided tape for the alignment nub.

Put the M3 Screws through the top of the bed, and Screw on the barrel nuts to the underside until snug. Align the middle Barrel nuts with the entrance to the tongue and the rear barrel nut to the entrance of the runner. Slide it forward till it clicks. Push all the way forward, and see the opening on the front where the alignment nub goes. Remove the bed.

Mark the spot with a Knife or Sharpie. Glue or tape the nub in place as seen in the pictures. Once installed re install the bed and it will lock down the front.