5.8L rice barrel drying box to prevent material from tangling with temperature and hygrometer

5.8L rice barrel drying box to prevent material from tangling with temperature and hygrometer

Boost
37
98
11

Print Profile(2)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
6.8 h
3 plates
5.0(1)

0.2mm layer, 3 walls, 18% infill PETG
0.2mm layer, 3 walls, 18% infill PETG
5.9 h
2 plates

Boost
37
98
11
7
333
9
Released

Description

原创5.8L米桶料架有以下特点

1.底部可容纳20cm*9cm*2.5cm的干燥剂,可使箱内干燥程度可达2%左右;

2.预留小米温湿度计2这款温湿度计的槽位,可从前方观察;

3.使用4个608轴承来作为滚轮,低速轴承不会使料盘转动过快导致缠料;

 

The original 5.8L rice bucket rack has the following features

1. The bottom can hold 20cm*9cm*2.5cm of desiccant, which can make the dryness in the box reach about 2%;

2. Reserve a slot for the Xiaomi Thermohygrometer 2, which can be observed from the front;

3. Use four 608 bearings as rollers. The low-speed bearings will not cause the material plate to rotate too fast and cause the material to tangle;

Comment & Rating (11)

Please fill in your opinion
(0/5000)

放不进去608
0
Reply
我用 626 可以
0
Reply
打印的时候你要选择608的盘
0
Reply
用PETG打印的,打印完完全放不进608轴承。
The designer has replied
0
Reply
额,不至于啊,我看好多人打印都能完美放进去呢,我模型的公差还是放大了的
0
Reply
我要重新打印,或者购买轴承了
0
Reply
真用不了
0
Reply
喜欢你这个设计,如果再能参考“TreeNB(亨利方)”那个打印轴承的一体化设计就好了。谢谢设计师分享!
0
Reply
牛逼的设计
0
Reply
根本用不了
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more