Colored Elliot

☕ Fuel the chaos or unlock perks and insider information at Buy Me a Coffee: The Toy Factory or Patreon: Patreon Community

😈 Creator License available inside

This is a colorized remix of an original brick figure model.

The original geometry was created by the original designer (credited below).
My contribution to this upload is color separation, filament assignment, and print-ready setup for multi-color printing.

This version is intended to help makers who:

• Want a ready-to-print colored version
• Are new to filament swapping / AMS setups
• Prefer a clean, assembled color layout

🎨 What’s Different in This Version

• Pre-configured color layout
• Clean color boundaries for easy printing
• Optimized for display and desk decor

No geometry changes were made—this is a visual and print-prep remix only.

🖨️ Print Notes

• Multi-color print (manual swaps or AMS)
• PLA recommended
• No supports required
• Prints best upright

🙌 Credit

Original Model: [Original Creator’s Name]
All credit for the base model goes to the original designer.
This upload is shared in accordance with MakerWorld remix guidelines.

⭐ Support the Community

If you find this colorized version helpful:

• 👍 Leave a like
• 🚀 Boost the model
• 💬 Check out the original creator’s page as well

These models don’t make themselves—just late nights, test prints, and a lot of “well… that didn’t work.”

If you’ve printed one or enjoyed the chaos:
☕ One coffee = ~50–100g of filament
👉 Buy Me a Coffee: buymeacoffee.com/Thetoyfactory

🎁 Patreon: Patreon Community

😈 Want to sell prints? Chaos Creator License available