Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
2 h
1 plate
Open in Bambu Studio
Boost
37
53
16
1
109
102
Released
Description
Voronoi Giraffe
Comment & Rating (16)
All
Boosted
Print Profile
0.16mm layer, 2 walls, 15% infill
nice clean print. used some lacquer on the textured PEI after reading some comments about adhesion. no issues with it as can be seen. probably due to the bottom not being perfectly flat.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Support Issue:bit finicky to get supports where you need them, but doable
Bed Adhesion Issue:the bottom isn't actually flat, you need a raft to print it well enough.
it's okay though
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
can not get this thing to print. Glue on the bed, slowed it down, still just a blob of filament.
0
Reply
That’s my same experience
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Printed very good with minimal supports.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
wife loves it thankyou
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
cute
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Support Issue
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Support Issue
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld