Display Shelf by Chase3d

Chase3d

Tools>Organizers

Print Profile(1)

All

P1P

P1S

X1 Carbon

X1E

0.2mm layer, 3 walls, 10% infill

Designer

7.1 h

4 plates

4.9(15)

Boost

273

382

396

277

Released

Description

This is another display shelf that breaks down easy to store for people who sell in public and need extra space when packing up. Petg is very strongly suggested. Pla WILL warp if hit with direct sunlight the weight of items on the thin boards will curve. So far have had no issue with petg. These were done in tinkercad and could be easily uploaded to add your own logo ect. and be completely customizable. Plus its great to have a display that can break down and lay flat in a bucket instead of taking of valuable space that could be used for product. Also have a raw version so it can be printed on larger printers for larger display sets. This is for personal use for commercial please see our cults page.

Comment & Rating (21)

@waya81

The stand printed fine, though I had some warping on the shelves. A picture of the side would have been useful to show how much overlap the shelves have. Only small items will fit, so it is not what I needed.

(Edited)

The designer has replied

@xakmom07

The shelves are adjustable as long as you deselect uniform scale. As pictured the items are smaller but it helps get stuff off the table and viewable. Sorry it wasn't satisfactory for you. As for the warping if you put a brim or lower the bed heat it will usually prevent the warping.

@waya81

Replying to @xakmom07 :

I didn't mean to imply that the warping was the fault of the file at all. It is something I have to fix on my side. This is the first time I've left a comment on Makerworld; it didn't give me an option to rate it, so I'm not sure where to do that. I would give it 5 stars because it was easy to print and assemble.

@xakmom07

Replying to @waya81 :

Thank you and no worries was just giving some tips. I think it has to be printed on bambu to rate it I have ran into that issue as well. I always appreciate feedback. Its the best way to learn and adapt

@user_3498613805

Print Profile

0.2mm layer, 3 walls, 10% infill

Great job, looks well and printed great!

(Edited)

@mrsbailey405

Print Profile

0.2mm layer, 3 walls, 10% infill

I made the bottom two a little wider to allow some larger models. love the print!

@bigmoe955

Print Profile

0.2mm layer, 3 walls, 10% infill

The designer has replied

@xakmom07

Thank you for your review

@michaelkallmann

Print Profile

0.2mm layer, 3 walls, 10% infill

The designer has replied

@xakmom07

Thank you for rating

@rweisal

Print Profile

0.2mm layer, 3 walls, 10% infill

@jameyy

Print Profile

0.2mm layer, 3 walls, 10% infill

@marti3dprinting

Print Profile

0.2mm layer, 3 walls, 10% infill

@ability44

Print Profile

0.2mm layer, 3 walls, 10% infill

@RIPrinting

Print Profile

0.2mm layer, 3 walls, 10% infill

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.