Print Profile(1)
0.2mm layer, 6 walls, 15% infill
Designer
7.4 h
1 plate
Open in Bambu Studio
Boost
13
16
6
2
19
4
Released
Description
it´s a Morocco style Lamp, with Ikea Led prepration for the light at the bottom.
It´s the most complicated and fine 3d print I have ever done and designed.
It fits on any Bambulab, even the A1 Mini.
I remember the stars in the desert in Morocco.
Adapted for this IKEA Led system:
KAPPLAKE LED-spot, hvid - IKEA
https://www.ikea.com/dk/da/p/kapplake-led-spot-hvid-20543157/?gad_source=1&gclid=Cj0KCQiA4NWrBhD-ARIsAFCKwWuPh4l66yR9Gz_8qKTov3RxIrs4vMIeaVDzHkLGnTY18bIbazFtPfUaAjl7EALw_wcB&gclsrc=aw.ds
Comment & Rating (6)
All
top! thank you!!
The designer has replied
0
Reply
thank you so much for sharing. looks great!
0
Reply
Dear Author,
The lamp is great, I've printed it, looks gorgeous.
I've also bought an IKEA Kapplake led for it, but I can't fit at all the led into the lamp. What am I doing wrong?
Thank you!
Anton
The designer has replied
0
Reply
Maybe the tolerances are a bit too tight. (I will change the design)
Try to make the cable connector slot a bit wider with a knife.
And then insert the led perpendicular to the hole and then spin to the right position
0
Reply
Print Profile
0.2mm layer, 6 walls, 15% infill
The designer has replied
0
Reply
thank you so much
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld