UNO Card Box
Copyright Claim
UNO Card Box
Boost
154
355
74
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
1.8 h
1 plate
Removed unnecesarry supports on the O.
2.2 h
1 plate
Boost
154
355
74
2
506
549
Released
Description
Print with 0.2mm layer height and position like shown in example.
To mount the hinge you need to use a piece of 1.75mm diameter filament
Comment & Rating (74)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
This printed great. I just coloured in the UNO words to stand out, which wasn’t my best effort lol
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Worked quite well but for the A1 Mini there are some uncecesarry supports.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
works like intended.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
nice
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
A really nice box, just had trouble getting the filament through the lid, went through the outer holes easily.
2
Reply
Same issue here, can't get the filament through the lid...
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Great box, to avoid drilling in the lid, I printed the parts separately: the lid in 0.16 mm layer and the box in 0.2 mm layer. It works perfectly.
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
You must drill through the center of the (card holder) hinge in order for it to fit the filament. The lid hole sizes are larger, and perfectly accomodating.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
worked fine thanks 🙏
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
wish the model had included hinge rather than a piece of filament. would have been stronger
0
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld