Oblong Incense Holder
Oblong Incense Holder
Boost
32
44
8
Print Profile(1)
0.15mm layer, 2 walls, 30% infill
Designer
47 min
1 plate
Open in Bambu Studio
Boost
32
44
8
0
101
79
Released
Description
A minimalist oblong shaped incense holder for smaller 120-150mm incense sticks.
Example images show the design printed in Bambu Labs marble PLA material at a layer height of 0.15mm.
This print is by no means optimised for speed as infill is modified to 30% and later height down to 0.15mm - but feel free to play with the settings.
IMPORTANT:
To ensure no scorching of the PLA, the design features an opening for an M3-4mm brass insert, the incense holder cannot be used without this addition.
Comment & Rating (8)
All
Print Profile
0.15mm layer, 2 walls, 30% infill
is too esmol I don't remind sorry :(
0
Reply
Print Profile
0.15mm layer, 2 walls, 30% infill
Other Issues:The design has too big a hole and does not hold the incense at the required angle. The ash will not fall in the tray. Otherwise, it printed ok. I'll need to stick some putty in the hole, or perhaps some epoxy...
The designer has replied
0
Reply
Hi! This design is actually intended to house an M3 brass insert to prevent scorching the plastic! It is also intended for smaller incense sticks :) Happy to publish a second, larger design if you wanted one?
0
Reply
Print Profile
0.15mm layer, 2 walls, 30% infill
0
Reply
Print Profile
0.15mm layer, 2 walls, 30% infill
Worked perfect
1
Reply
Print Profile
0.15mm layer, 2 walls, 30% infill
Other Issues:the holder hole is not fit for the Incense stick it is too big
0
Reply
Print Profile
0.15mm layer, 2 walls, 30% infill
0
Reply
Print Profile
0.15mm layer, 2 walls, 30% infill
Other Issues:a little too small
0
Reply
No more
License
This user content is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld