Small Multicolor Test Remixed by JakobF

Remixed by

JakobF

3D Printer>Test Models

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

A1 mini

0.2mm layer, 2 walls, 20% infill

Designer

26 min

1 plate

4.5(25)

0.16mm layer, 2 walls, 15% infill

Designer

32 min

1 plate

3.7(3)

Boost

187

199

Released

Description

Ultra fast printing presliced model to test multi color printing. Prints in less than 30 minutes and only has 3 layers. If you only want to test two colors assign the same material to two parts of the square.

Perfect to test AMS function after installing a Y-Splitter to see if everything runs smoothly.

Comment & Rating (33)

@faluethi108

Print Profile

0.2mm layer, 2 walls, 20% infill

Good and quick test. I used it because i had trouble with the ams pulling the filament back and tested the mods i installed.

The designer has replied

@JakobF

Exactly what it was meant for! I designed it to test several Y-Splitters... Thank you!

@mindlessdad

Print Profile

0.2mm layer, 2 walls, 20% infill

This model is super tiny and while is does test out the AMS swap colors and slots the purge tower is like 4x bigger than the little model and so there is a lot of unnecessary purging.

@Rockman

Print Profile

0.2mm layer, 2 walls, 20% infill

Nice

@dboda

Print Profile

0.2mm layer, 2 walls, 20% infill

@3DLITHOPHANES

Print Profile

0.2mm layer, 2 walls, 20% infill

didn't print right.

The designer has replied

@JakobF

Any more specific issues? So far I (and others) printed it multiple times without any problems. If you specify more I can create an updated print file.

@3DLITHOPHANES

Replying to @JakobF :

I looked into it and it wasn't the print file it was a problem with my x1 I tried printing it again and it was just fine.

(Edited)