I decided to try and add some color to the other hueforge I made. I hope you all like it!
If you only have one ams system the trick to printing with more colors is to leave one color slot unloaded, then when the printer pauses so that you can load the filament this is the time you can switch out the other colors also.
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Pink Transmission Distance: 8
PLA BambuLab Basic Gray Transmission Distance: 2
PLA BambuLab Matte Grass Green Transmission Distance: 2
PLA BambuLab Basic Beige Transmission Distance: 8
PLA BambuLab Basic Jade White Transmission Distance: 5
Swap Instructions:
Start with Black
At layer #13 (1.12mm) swap to Pink
At layer #16 (1.36mm) swap to Gray
At layer #19 (1.6mm) swap to Grass Green
At layer #20 (1.68mm) swap to Beige
At layer #23 (1.92mm) swap to Jade White for the rest.