Ecotech Radion XR30 Gen5/6 Shround
Copyright Claim
Ecotech Radion XR30 Gen5/6 Shround
Boost
6
7
2
Print Profile(1)
0.2mm layer, 2 walls, 15% infill, support normal auto
Designer
6.7 h
2 plates
Boost
6
7
2
0
27
30
Released
Description
This is a light shroud to block the majority of the light from reaching the ground from Ecotech Radion XR30 Gen5/6's.
It prints in 2 pieces and snaps together in the middle around the light. No glue necessary.
It should be printed in a high temp tolerant filament as the lights get pretty hot. I used ABS.
Comment & Rating (2)
All
Print Profile
0.2mm layer, 2 walls, 15% infill, support normal auto
took three times to print the second half, once assembled it was roughly 1 to 1.5. inches too long
The designer has replied
0
Reply
Hey thanks for trying my print! The extra length was intentional as it allows more light to spread along my tank lengthwise while not spilling too much.
(Edited)0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld