Chocobo Coloured

Copyright Claim

Chocobo Coloured

Boost
20
27
5

Print Profile(2)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
5.7 h
1 plate
4.5(2)

0.2mm layer, 2 walls, 15% infill, 250% size, Tree Slim supports, no Brim, 4 colors
0.2mm layer, 2 walls, 15% infill, 250% size, Tree Slim supports, no Brim, 4 colors
11.4 h
1 plate

Boost
20
27
5
0
41
21
Released

Description

Pre coloured Chocobo - scaled small but can be upscaled fine - all feather textures applied using zbrush

Use my profile for supports.

 

Enjoy

Comment & Rating (5)

Please fill in your opinion
(0/5000)

I printed 3 of these and I already broke the legs of one trying to remove the supports... Any advice to not ruin the other 2? Other than that looking great!
The designer has replied
0
Reply
Hi The bottom middle supports are close especially if printing at the original scale. I recommend snipping the support just below the body of the chocobo and then pulling downwards so as not to damage the thin!! :) legs. Hope this helps
0
Reply
Replying to @brentglover1970 :
Ok thanks, I'll give it a try!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I had to colour the parts myself to use only 4 colors and had to increase the size and reduce the supports for the legs not to break, but amazin model! Looks awesome!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more