perfect fit phone case for ROG phone 6.

circle cutout is for meant for pop socket. so that it sticks out less.

I hadn't realized they had a twits lock feature on the back. I would probably mold the twist lock geometry in instead for a V2.

no AMS required.

• make sure the pauses are correctly set on layer 0 and 8 of the case body and that z-hop ≥0.4mm is enabled.
• print thinker inlay in filament 1.
• start case print, during the pause swap to filament 2.
• when it pauses again swap to TPU, !!!MAKE SURE TO FORCE NOZZEL TEMP TO 240 FOR TPU TO BOND!!!

you could do it all in PLA if you don't take it in and out of the case many times it won't flex enough to crack. but if you do this change the material settings and re-slice, TPU prints much slower.

PS: the yellow wasn't a really a choice, it's the only TPU roll I had.