Insert for Toxic Waste Lamp

Remixed by

Insert for Toxic Waste Lamp

Remixed by
Boost
8
32
6

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
2.3 h
1 plate
5.0(5)

Boost
8
32
6
2
47
32
Released

Description

Like a lot of people, I printed the slick Toxic Waste Barrel but found out my yellow allowed too much light and you could see the square of green behind the radiation symbol. This is an insert that slips into the barrel and gives you 360 degrees of color. It adds a slight green cast to the yellow but I kind of like that. I made this in the vase creator, then made drips in Photoshop and subtracted those around the top. It adds a little texture to it. I might add a second model later that is just the drips. That would let you print the drips in a darker color. Depends on how many people use it. I recommend brimming this. I didn't make a cut out for the cord, it fits just fine without it.

Comment & Rating (6)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 2 walls, 15% infill
Printed in Green Glow PLA, same as the bubbles and front cutout. Makes nuclear symbol way more green and adds a little glow to the piece. Thx
0
Reply
you could do another remix with hands and body parts that would show when lit up. like they're decaying in acid 🤘
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
👍
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more