Set of 3 hole size gauges circle hex rectangle square
Copyright Claim
Set of 3 hole size gauges circle hex rectangle square
Boost
7
12
3
Print Profile(2)
0.2mm layer, 2 walls, 15% infill 2 colour for AMS
Designer
9.9 h
3 plates
0.2mm layer, 2 walls, 15% infill text is inset for single colour/Non AMS
Designer
7.4 h
3 plates
Boost
7
12
3
0
19
8
Released
Description
Hi, I have made a set of 3 size gauges with holes ranging from 2mm to 10.9mm in .1mm increments which I use to work out the size of holes in models to allow magnets, bolts, screws nuts, etc to fit snugly as every printer gives slightly different results you can't always rely on taking measurements.
I've included 2 sets of models, one with the text inset for any printer and one with the text flush for printing on a Bambu AMS is multicolour. If you're printing these in multicolour they print better with the text facing down on the build plate.
Comment & Rating (3)
All
Print Profile
0.2mm layer, 2 walls, 15% infill 2 colour for AMS
I have only printed the circle gauge so far and it printed great.
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill 2 colour for AMS
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill 2 colour for AMS
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld