SOVOL 3D FILAMENT DRYER LID GASKET
Copyright Claim
SOVOL 3D FILAMENT DRYER LID GASKET
Boost
17
30
6
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
30 min
1 plate
Open in Bambu Studio
Boost
17
30
6
0
25
19
Released
Description
I created this TPU gasket to create a lot tighter seal for the Sovol 3D filament dryer. The stock gasket creates a loose fit and the lid can shake allowing air to enter. Print this in TPU. The lid and locks may feel really tight trust me it will lock and seal perfectly. Attached is the .step file and a bambu sliced .3mf
Comment & Rating (6)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
prints good, doesn't take very long
0
Reply
it doesn’t fit properly!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
nao funciona!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Did not fit the dryer, too big.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld