Percussion frog (guiro)
Remixed by
Copyright Claim
Percussion frog (guiro)
Remixed by
Boost
88
114
13
Print Profile(1)
0.16mm layer, 2 walls, 100% infill
Designer
13.3 h
2 plates
Open in Bambu Studio
Boost
88
114
13
3
347
122
Released
Description
I split the frog to two halves so the supports are inside the frog and you get a clean outer surface. You can glue the pieces together, however it's not necessary, the connectors are press fit.
Comment & Rating (13)
All
Boosted
Print Profile
0.16mm layer, 2 walls, 100% infill
sehr schönes Modell, gedruckt mit Farbwechsel PLA (wechselt die Farbe je nach Temperatur)
0
Reply
Print Profile
0.16mm layer, 2 walls, 100% infill
great print quality in PLA from no name brand
0
Reply
Irgendwas hat nicht ganz geklappt. Die Froschhälften passen maßig aufeinander, der Klang ist gut (quaaaaak). Aber mir bleibt nichts anderes übrig als den Frosch zusammen zu kleben, für die kleinen Verbindungsstifte gibt es keine Bohrungen in den Hälften.
0
Reply
Print Profile
0.16mm layer, 2 walls, 100% infill
This is my favorite print so far, it’s very fun and the whole family wants one
0
Reply
Printed at 240% - about the max size the baseball bat can be and fit on my P1S - Worked well. :)
1
Reply
Print Profile
0.16mm layer, 2 walls, 100% infill
wirklich tolle datei
0
Reply
Print Profile
0.16mm layer, 2 walls, 100% infill
printed great. sounds cool. couldn't get pegs to fit in holes so I just glued together
0
Reply
Print Profile
0.16mm layer, 2 walls, 100% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 100% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 100% infill
0
Reply
© 2024 MakerWorld