Super quick, dirty, mashup of 2 other great spool holders. Shamelessly brought into software, merged and tidied up a little, and printed at 0.2, on the default strength profile for my X1c. Holds the spool holder from the A1 with no problems.
👌🏻
I would tighten up the length of the clamping area a little bit. I’ve been planing on revising mine but haven’t done it yet. the holder jiggles around a bit too much for my liking with all that room.
Otherwise great job.
Yeah good call. mine clamps hard enough that it's not moving at all, so in the interest of not wasting plastic I probably won't revisit this unless a problem becomes apparent in use. Been going all night with a TPU print without any movement of the clamp at all. Thanks for the original file though, it was SUPER helpful.