AMS stacking stand - leg extension
Copyright Claim
AMS stacking stand - leg extension
Boost
36
71
18
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
6.1 h
2 plates
Boost
36
71
18
1
157
100
Released
Description
Adding futher height to MihaiDesigns brilliant AMS stacking stand for bambu labs printers so that the lid of the lower AMS can fully open.
Good for tighter spaces so that the bottom AMS doesnt need to be slid forward to load/unload spools.
Included 3mf file is setup to print both left & right models on their own plate @ 0.20 with supports for the slots (untick on build plate only if you are downloading STLs).
Standard walls and infil is fine.
Original model by MihaiDesigns here.
Comment & Rating (18)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Functions perfectly
(Edited)
1
Reply
i have done something stupid... i printed 2x of plate 1. the last print is 75% done. will 2 of the same leg work?
The designer has replied
0
Reply
Urm not sure! Its been a while, how did you get on?
0
Reply
Replying to @BCDesigns
it worked fine! phew haha
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Passt perfekt, hab die etwas höher Skaliert damit es die komplette druckplatte füllt. hab unter den ersten noch eine Schublade. Mega, Danke!
1
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
Works fine for me... thx !
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
© 2024 MakerWorld