Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 4 walls, 50% infill
Designer
42 min
2 plates
Open in Bambu Studio
Boost
11
41
3
0
14
8
Released
Description
Content has been automatically translated.
On our Standup Paddle Board (from Mistral), the rear fin needs to be fixed with a small screw. Since loosening the screw with fingers is quite difficult, I designed this small tool.
With the tool
- you can easily screw and unscrew the screw
- store the screw with it when not in use so it doesn't get lost
I printed the tool in yellow PLA Tough+ so it's very noticeable and doesn't get lost.
The tool was entirely designed in Bambu Studio. In addition to the merged print-ready object, the raw design can be found on a second plate, allowing anyone to adapt it to their needs.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (3)