Brick Man Advent Calendar Head Ø204mm without AMS
Print Profile(1)
Description
21.11.2025: Change without supports for the middle part
Plate 1 on the head unchanged, Plate 2 and 3 on the head have changed
Now it should work for everyone without problems
20.11.2025: Support change
Since problems with supports are increasingly appearing, I made a change to the head based on a hint that it works this way
There are now holes at the bottom where it rests, the supports are now only on the print bed
The holes do not bother, the calendar is emptied layer by layer, when the hole becomes visible and you look into the lower drawer, there is already nothing left in it
If you have already started with it, you don't have to print anything new, the calendar is only 1mm higher if you combine the old and new versions
I present here the Brick Man Advent Calendar, the head has a diameter of 204mm
no AMS is required
A tool for pulling out is integrated into the head, each individual compartment is fixed in the head so that nothing falls out when flipped over
I have divided the head into 3 parts, you can glue the surfaces together, but it is not necessary, then just screw them together
Have fun with it 😉
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (161)