This is a hueforge print.
You can print it without an AMS!
Hotend: 0,40mm
Print time: 2:07h
Filaments Used:
PLA Sunlu Meta Black
PLA Sunlu Meta Grey
PLA Sunlu Meta White
Filament swap Instructions:
Start with Black
At layer #8 (0.72mm) swap to Grey
At layer #14 (1.2mm) swap to White for the rest.
Slicer instructions:
Before printing, make sure your build plate is clean and apply some adhesive. Wash the build plate with oil free soap and wipe it off with some paper towels. For build plate adhesion, apply a thin, even coat of your preferred adhesive. I repeat the process every 5-6 prints.
Bad build plate adhesion is not related to the model.
Please check out my other models https://makerworld.com/en/u/1597610120 and leave me a like and a decent rating if you were satisfied. Thank you in advance!