I had a set of cabinets that had a drawer hanger break, This model required a left and a right hanger. After looking around on the internet and ordering what looked to be the closest thing I could fine I realized that I would be better off just designing a stronger version and also making it interchangeable. I've been using this hanger for over a year now with zero issues so I figured I'd share the file before I lost it. I hope this comes in handy for others.
I printed it face down for the most strength on the pulling axis so use supports for the bottom.
I also printed it with 100% infill but may not be needed.
Printer Brand:
Anet
Printer:
A8
Rafts:
No
Supports:
Yes
Resolution:
200
Infill:
100
Notes:
I've got two hangers installed, One is ABS and the other is PLA both have zero signs of wear after 1 year.