Focusrite Scarlet 4i4 - Angled desk stand
Focusrite Scarlet 4i4 - Angled desk stand
Boost
2
6
2
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
34 min
1 plate
Open in Bambu Studio
Boost
2
6
2
0
6
8
Released
Description
Summary
A minimal angled desk stand for the Focusrite Scarlet 4i4 so the knobs are a little more accessible and visible.
15cm wide by 10cm deep
Can be used for other Focusrite devices as well.
Feedback is welcome!
Updated Version 2
Uses far less filament and less print time
Old Version 1
This version was to rudimental and since the base was big and useless it used a lot of unnecessary filament. Version 2 resolved that.
Print Settings
Rafts:
Yes
Supports:
No
Resolution:
0.3
Infill:
10%
Filament:
BASF Ultrafuse Pick your flavour
Post-Printing
- Added some vinyl feet to prevent from sliding on the bottom
- Added some vinyl on the touching point to prevent sliding/scratching.
Comment & Rating (2)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
This print fits under my Motu M2 interface perfectly, although I did increase the walls value to 3 and slightly more infill with PETG. The upwards angle is perfect for a desk and the simple design works like a champ. Thanks!
The designer has replied
0
Reply
Great to hear it works a good for you as well!
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld