Search models, users, collections, and posts
Compact Controller Stand
Remixed by
IP Report
Print Profile(3)
0.24mm layer, 2 walls, 10% infill
Designer
6.1 h
1 plate
Lightning infill. Less time, less weight, less stable.
Designer
4.8 h
1 plate
Tower cut in half, A1 mini 0.24mm layer, 2 walls, 10% infill
5 h
2 plates
Open in Bambu Studio
Boost
333
935
117
65
1.3 k
812
Released
Description
Remix of Dadtaxes3D's controller stand.
I noticed that others were having a bit of trouble with the stand and the base not screwing in as they were supposed to. So I took the original main part of the stand and created a new base which was merged with the tower.
For this to turn out ok since it stands vertically, I had to use tree supports for the holes in the model.
I added a print profile with lightning infill. This one takes less time to print, but it's less stable due to its decreased weight. So be careful when adding or removing your controllers.
If you see room for improvement in the model, feel free to leave a comment! :)
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (117)