BambuLab Storage Tray (Fits Ikea Alex)
Copyright Claim
BambuLab Storage Tray (Fits Ikea Alex)
Boost
52
117
18
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
8.2 h
2 plates
Boost
52
117
18
0
150
102
Released
Description
This is a simple remix of the storage box by Austin Smith. Designed to fit perfectly in an Ikea Alex drawer(there will be a slight gap to compensate for the screws in the drawers), but can obviously be used on or inside other desks. I also put rubber pads on the bottom so they would not slide when opening/shutting the drawer.
The compartments for the belt boxes/small part boxes are snug. This was a quick remix so if you run into any issues feel free to let me know.
Printed at .2/20% infill/no supports.
If you found this useful, please consider buying me a beer!
Comment & Rating (18)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
👍
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
clean print
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Project done well, I needed it just for my Ikea Alex drawer. Very good
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Incroyable !!!!
0
Reply
Super, merci..👍🏽
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
passt sehr gut, bitte mehr davon 👍
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld