I needed a stand to hold the charger for my watch, it was hard to use, constantly falling on the floor and my watch sometimes pops off due the way the charger sits on a surface.

I tried to find a stand but other than a rectangle block someone made... I decided to design a stand on my own and as a result, my first ever 3d design.

This will work on the charger that came with the 42mm oppo watch, I do not know about the 46mm.

It's basic, I'm no expert, you are welcome to provide suggestions.

It prints in 2 parts to save on support material, you may need to sand down the legs to slot into the hole depending on how well it prints but you do not want to go mad, it should be a snug fit so it does not fall apart.