Easy to print paperweight that also decorates your office

It uses less than 50grams of filament total, so you can take advantage of almost any unfinished roll of filament

Printing Tips:

-check your sliced file before printing to make sure text lines will print well. The result may vary depending on your nozzle, so you can change the “thin walls” parameter until you get it right.

-the tolerances are a little tight, so make sure you don't have "elephant foot” in your printer to get them to fit right. if you can't avoid it then you just have to scrape or sand the base of each piece a little to make it fit. And if they are a little loose, use some glue to hold them

Print Settings

Material: PLA / PETG

Layer height: 0,16 - 0,24

Nozzle diameter: 0,4mm or 0,6mm

Infill: 10 -12%

Perimeters: 2

Supports: no

Thanks for your download. you can find my other designs here

Diego Alvarez | Published - MakerWorld

________________________

You can find other exclusive models on this collection, and license to sell physical prints in my patreon.

https://www.patreon.com/meafdesigns

________________________