8mm OD Rod
22mm OD x 8mm ID x 7mm High- Bearings x2
1x Raspberry Pi 3 Modell B - Quad-Core Processor / 1GB RAM WiFi Bluetooth on Board
1x 8GH Micro SD card
I wasn't happy with the CR-10 v3 spool holder so I designed my own because with the original holder you are limited to 80mm/s printing speed, I'm trying to reach between 120/mms-150mm/s but you will have to remove the filament sensor and place it on the gantry , it works with the following design: https://www.thingiverse.com/thing:4773936
!!!Note: I'm always open for suggestion and help on improving the design and proof of concept.
!Don't forget to check out my other Cool designs and Follow my Weekly dose of KooKoo uploads
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.3
Infill:
15
Notes:
6 Shells/Walls