Dice Tower FF7 Cloud's Buster Sword for DND
Copyright Claim
Dice Tower FF7 Cloud's Buster Sword for DND
Boost
22
32
2
Print Profile(1)
0.16mm layer, 2 walls, 6% infill
10 h
1 plate
Boost
22
32
2
1
39
5
Released
Description
I made a dice tower from clouds buster sword from FF7. This prints in 2 parts. They should print without supports. I would beef up the infill so the sword is standing nice and strong.
Comment & Rating (2)
All
Print Profile
0.16mm layer, 2 walls, 6% infill
i thought this was a really cool setup. having printed it... it kinda let me down. the hilt doesnt stay on. there is a ridge at the bottom of the sword where the die gets stuck on on an edge faulting the roll. it looks amazing but the functionality wasnt as good as expected. would not print again.
1
Reply
Hey thanks for the information. I’m sorry it doesn’t work for you. I’m going to pull this from makerworld and upload again once I get it fixed.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld