Strong stackable plant support
Boost
18
43
10
Print Profile(1)
0.16mm layer, 2 walls, 15% infill, supports included
Designer
55 min
1 plate
Open in Bambu Studio
Boost
18
43
10
1
61
77
Released
Description
A strong plantsupport, with the possibility to stack on itself. The legs can be pressed firmly in the hexagonal base.
Depending on your printers tolerances you maybe need to glue them, to keep it all intact in case you´re planning to move the supports around several times.
Width is approx 100x100mm and fits nice in smaller variants of pots.
Prints with small supports in the holes for the legs. It is possible to print without, but the legs can be a bit tricky to get in then.
Comment & Rating (10)
All
Print Profile
0.16mm layer, 2 walls, 15% infill, supports included
printed this to hold up my baby lemon tree. been doing it's job. love how you can keep adding to it.
1
Reply
Boosted
Print Profile
0.16mm layer, 2 walls, 15% infill, supports included
works perfectly for my plant
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill, supports included
Passt
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill, supports included
Good model. The only thing I would change, would be to make the ends of the risers round instead of hexagonal. Making this change would allow for running a drill bit to clean out the holes to get support material out of them.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill, supports included
(Edited)
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill, supports included
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill, supports included
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill, supports included
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill, supports included
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill, supports included
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
© 2024 MakerWorld