Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
3.1 h
1 plate
Open in Bambu Studio
Boost
13
16
3
1
33
5
Released
Description
This time I bring you a tiger on fire, according to the previous version in the software, if you change the gray to blue you also get good results but I preferred to print in gray.
I have made modifications after printing because the black base was too thin, now it should be better. I hope you like it!!
Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA PolyTerra Lava Red Transmission Distance: 1
PLA BambuLab Basic Yellow Transmission Distance: 6
Swap Instructions:
Start with Black
At layer #14 (1.2mm) swap to Blue Gray
At layer #19 (1.6mm) swap to Lava Red
At layer #29 (2.4mm) swap to Yellow for the rest.
Comment & Rating (3)
All
Boosted
printed beautifully at standard settings.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld