Tokyo Ghoul Ken Kaneki LED Lightbox by 3DRicks

3DRicks

Art>Signs & Logos

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

6.7 h

2 plates

Open in Bambu Studio

Boost

Released

Description

Tokyo Ghoul Lightbox

printed with 3 colors and after adding a led strip you get an awesome lightbox.

The hole in the back is 15mm wide

Comment & Rating (4)

@Xaedilis

Printed and came out great, Just sucks the extrusion calibration was left on and the extrusion calibration got into the print. Would not be an issue if the first color It did the calibration was black but in my case it was red. I also printed this in gray bambu tough filament and it came out pretty good (Ran out of white filament)

The designer has replied

@3DRicks

thanks for the comment, i will have a look on that. Which Printer did you used and can you share some pictures?

@Xaedilis

Replying to @3DRicks :

Absolutely! I used the Bambu Labs X1 Carbon Printer, used your exact settings from the 3mf. If you look all the way at the bottom you can see the red lines and that’s because I set the extrusion flow calibration on. some of it peeled off but most of it stayed there. if I wanted to print it again I’d make sure to turn that off before printing but my girlfriend loved it so I didn’t need to reprint. Thanks again for the design I got major brownie points for it hehe

@3DRicks

Replying to @Xaedilis :

ahh okay thank you, it's because i only tested it on the A1 and there are only 2 small extrusion lines. I will update the files for the X1. Thanks again

No more