You are looking for a way to present your favorite Benchy?

Then set your Benchy against the backdrop of a stormy sea with this Display!

For the Benchy, a fitting cutout has been incorporated into the waves. This allows your Benchy to sit nicely in the display but can be easily swapped out at any time.

There are two sizes to choose from: 
-The small model prints in just over 3 hours at a layer height of 0.2mm. This uses 70g of material. The surface can be further improved by using Adaptive Layer Thickness, but it still looks great at 0.2mm.

-The large model takes about 6.5 hours and 150g of material.
 

I've also experimented with different infill types. However, the Lightning Infill doesn't save as much material as expected but significantly reduces strength. Therefore, I've opted for a coarse gyroid infill.
 

Check out my other models as well, and feel free to upload your print photos!

https://makerworld.com/en/u/3624704578