----------------------

ONE SERIES, ONE FAMILY

Adult model but in standing position: Holiday Christmas Deer - Low Poly
Adult model but in laying position: Laying Christmas Deer - Low Poly
Youngster model: Youngster Christmas Deer - Low Poly
These 3 models go very well together placed next to each other

PREAMBLE

This is a remix of a well-known Holiday Christmas Deer model by YEG 3D back from 2014:
https://www.thingiverse.com/thing:571949

As I'm a big fan of Low Poly models, I've decided to do a Low Poly remix of this gorgeous model.

Many brave souls have failed to print this one, again, again and again. Lots of filament is wasted into nothingness. This print will require a well-calibrated and tuned 3D printer.

To save you a headache, consider using the attached GCODE or 3MF file - it has all the correct settings.

SIZE

The attached GCODE/3MF is made to fit the model on Prusa MK3S+.
Feel free to size it up or down as you wish.
I strongly suggest sizing it up to fit your entire heat bed as it gives the best result.

SETTINGS

Filament: PLA+ (as pictured in the photo)
Print: 0.2mm
Nozzle: 0.4mm
Support: Not needed
Brim: Yes, 8mm
Infill: 5%

If you're so brave as to use STL instead of the GCODE/3MF, ensure to sink the model at least 1-1.5mm into the heat bed before you print it.

NOTES

Support and Brim - do notice the small support for the back left leg - it can be snapped off after printing. The brim is there to ensure the stability of the legs while printing.

Bridges - Oh yes, this is where most of the printers will fail. This is how my model looked after printing. But fear not - the excessive parts can be easily cut with a scalpel, and it's not noticeable at a 0.5m distance.

Stringing - Yes, it's present. Once again, it's perfectly manageable and removable using a sharp scalpel and small scissors. Take your time and you'll be rewarded!

Happy Printing!

--------------